Move Move

Inputs/Outputs Operands Data Types
IN VB, IB, QB, MB, SB, SMB, LB, VW, IW, QW, MW, SW, SMW, LW, AIW, T, C, VD, ID, QD, MD, SMD, SD, LD, HC, &VB, &IB, &QB, &MB, &SB, AC, Constant, *VD, *AC, *LD BYTE, WORD, INT, DWORD, DINT, REAL
OUT VB, IB, QB, MB, SB, SMB, LB, VW, IW, QW, MW, SW, SMW, LW, AQW, T, C, VD, ID, QD, MD, SMD, SD, LD, AC, *VD, *AC, *LD BYTE, WORD, INT, DWORD, DINT, REAL

Memory Ranges ENO Errors Instruction Support for S7-200 CPUs SIMATIC/International Mnemonics
The Move and Assign Values instruction moves the value IN to the address OUT. This instruction performs an assignment operation. The input parameter is not modified during execution.

The input and output data types can vary, but must be of the same type.

Error Conditions that Set ENO = 0:

SM4.3 (run-time), 0006 (indirect address)