Remove Input (FBD Only)

Remove an input line from an AND box or OR box, in a FBD program, if extra inputs have been added:

·Place the cursor on an AND box or OR box, then click the Remove Input button.

·Place the cursor on an AND box or OR box, then press the “-” key to remove an input line.

Repeat this procedure to remove additional extra inputs.

Note:

A 1 input AND box is supported. The 1 input AND box is the FBD program view of a single STL LD instruction or a single LAD contact. To place a 1 input AND box in your program, use a 2 input box and then delete 1 input with the remove input button.

See Also:

Add Input

AND and OR use in FBD

How to Enter Instructions in FBD

Application User Reference

Getting Started Contents